ZMP1102B Basic Pneumatic Training Panel Pneumatic Trainer Mechatronics Training Equipment
1. Structure
Basic pneumatic trainer is designed for “hydraulic and pneumatic training”, it meets modern pneumatic transmission requirement. Students can learn basic pneumatic circuit control knowledge, and practice hand on ability. Pneumatic trainer combines electrical and mechanical transmission knowledge.
This trainer is suitable for colleges, engineer university, technical schools, vocational schools, engineer training centers, factory training department etc.
Through this trainer, students can master pneumatic components structure, pneumatic circuit control theory, pneumatic circuit design, and hand on ability for pneumatic trainer.
This trainer is flexible and students can design their own pneumatic circuit.
2. Introduction
1. Panel type, without workbench, it is easy for transportation.
2. Every pneumatic component is an individual module, it has quickly plug in and plug out sockets, can put in aluminum panel and build pneumatic circuit.
3. Use stainless air compressor, running has low noise, it supply good environment for training.
4. Pneumatic circuit use quickly plug in and plug out leads, it is suitable for students to build pneumatic circuit. Students can combine theory to practice, and practice hand on ability.
5.Transparent components structure, it is easy to observe. It is with beautiful look.
3. Technical parameter
(1) Slot space:25mm
(2) Panel material: aluminum
(3) Dimension 1200*750mm
4. Technical parameter
(1) Slot space:25mm
(2) Panel material: aluminum
(3) Dimension 1200*750mm
5. Basic structure
Pneumatic control experiment workbench including experiment workbench, experiment shelf, pneumatic components etc.
Pneumatic components and real equipment: air filter, decrease pressure valve, service unit, hand-operated direction valve, pneumatic control direction valve, strike valve, check valve, throttle valve, exhaust valve, single acting cylinder, double acting cylinder etc.
